AquaViva SP900

Proper Maintenance of Filter Media & Electrode Plates

   
Platinum / Titanium Electrode Plate Cleaning Kit
   
Step 1 Remove the power cord from electrical socket  

Step 2 Slide off the back cover by pushing it gently to the left as shown below.

   

Step 3 Remove the filter by pushing down on the top and pulling it towards you. (similar to the action of changing a toilet paper roll)

 

Step 4 Insert the new filter into place keeping the Green Dot on top. Push down and away from you to enter the filter in place. Slide the back cover back in place.

 

Step 6 Plug the Aqua Viva power cord back into the electrical socket.

Let the water run through ionizer for 2 minutes to eliminate any carbon powder before drinking

 

 

Step 7 Reset the filter life cycle by pressing on the "FUN" button from the control panel on top of the Aqua Viva water ionizer until you see the "Cln" showing on the LCD Display. Then click on the "SET" button once followed by pressing once on the "-" Reset button. You will notice that the filter life returns to 00000L. This completes the Filter Life Cycle Counter.

 

 

 

 

 
     
 

The information found on All Water Needs.ca is source from various peer reviewed literatures as well as various Internet sites. This information is for educational purposes only and is not meant to imply in any way that these products are used to cure or treat any diseases or illnesses. Always consult your doctor for specialized medical advice.

*All Water Needs.ca is a registered domain owned and operated by Jesse James Consulting Inc.

 
 
French Site: www.leauolympique.ca/index.html